Dukane 210 Manuale Utente Scaricare il pdf (Pagina 61)

Dukane Manual Part No. 403–558–03

Section 5 – Rear Connectors

Multi–Point Master Module

Part No. 110–3954

This optional module enables the DPC II to

activate any one of four ultrasonic probes. Each

probe is selected by the Probe ID# (pins 12, 13

& 14) of the HD–15 System Input connector

(see Table 5—II). Rear panel bicolor LED status

indicators for each probe output illuminate green

when the probe channel is selected and red when

the U/S is active. The Multi–Point module is only

compatible with the Rev–1 DPC II motherboard.

Both a MPC Master and Slave module are shown

below in Figure 5–14.

Internal logic prevents more than one probe from

being activated at a time or probe switching signals

when the U/S is on. A ring-down circuit permits

switching only when U/S output is zero. Internal

fault logic senses any malfunction and deactivates

the MPC Ready output. The Multi–Point Controller

cannot be used with a press module. The master

module has an extra wide back panel to prevent

it’s accidental use with the press module.

Multi–Point Slave Module

8 Ultrasound Outputs

(4 per Module)

Ultrasound

Input from J1

MPC Master

Module

P/N 110–3954

MPC Slave

Module

P/N 110–3956

Part No. 110–3956

This optional module adds four additional probe

selection channels to the DPC II. This gives a

total of eight probe channels. The slave module

cannot be used alone. It must be used with the

master module. An internal connector supplies

the ultrasound signal from the Master module. As

with the Master module, each output channel has

a bicolor LED status indicator that illuminates

green when the probe channel is selected and red

when the U/S is active.

NOTE 1

External automation

can be used to select

the probe. In a DPC

II system, the exter-

nal automation also

controls the weld and

hold times.

NOTE 2

The Ultrasound in-

put on the MPC

Master must be con-

nected to the DPC

Ultrasound output

connector with a

RG62B/U coax. This

is indicated as Cable

2 in Figure 3–6 (Part

No. 200–479–01).

Figure 5–14 Master and Slave Multi–Point Controller (MPC) Modules

Rev–1

COMPTABILITY

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 145 146

Commenti su questo manuale

Nessun commento

Dukane 210 Manuale Utente Pagina 61

Commenti su questo manuale

Prodotti e manuali riguardandi Fotocamere bridge Dukane 210